Company Name and Your Name:
*
*

*Phone Number: 
*Fax Number:
*E-Mail:

*Tank Size

Diameter:
Length in Inches:
Capacity in Gallons:
Design Pressure (psi):
ASME Code     Non-Code
Carbon Steel   Stainless 304 Stainless 316

*Fittings

Manways:  11" X 15"   12" X 16"   Special Size
Handholes:  4" X 6"   Special Size/Type
Number 2" & Smaller Couplings
150# Flanges   Pad Flanges
Quantity:  2"   3"   4"  5"    6"    8"  10" 

*Tank Mounting

Vertical:  Style I Skirt   Style II Skirt   Angle Legs WFI Beam Strap Legs
Horizontal:  Style I Saddles   Style II Saddles   Skid

*Tank Lining

Epoxy (Cold Water)   Epoxy (Hot Water)   Galvanized   Potable Water
Other

*Exterior Painting

Standard Shop Primer   Enamel   Special Coating
Other

Tank Accessories

Site windows (size)
Internals (describe clearly)

Special Requirements

Destination:

TANK HEATING TUBE BUNDLE (If needed)
To select the proper unit, you need to know:  The load, usually expressed as draw in gallons per hour (GPH) to be heated from an entering water temperature (if unknown assume 40°F) to some higher water temperature in degrees Fahrenheit.  The size of the tank in gallons.  The heating medium, either steam at some gauge pressure or hot water at a temperature at least 10°F higher than the design discharge temperature.  The location of the bundle in the tank.  Any special conditions such as Rapid Recovery, tank to be maintained at design discharge temperature, tank to be continuously circulated, limited volume of heating medium or tank is cement lined.

Tubeside
Fluid Type:
Flow Rate (GPH):
Entering Temp. °F
Leaving Temp °F
Load:
Average Temp. Diff.
Special Conditions:

Tankside
Fluid Type:
Flow Rate (GPH):
Entering Temp. °F
Tank Temp °F
Load:
Special Conditions: